How to operate the Release hook release recovery

We should keep a careful attitude in the recycling release hook, so that we can prevent accidents in the process of releasing and recycling, and to ensure the safe operation of the release hook and recycling. In our daily work, we should also ensure that the release hook and recovery operation of the reasonable specification, the tool itself should be kept in good condition. It is very important to check this process frequently, such as lifeboat davit wire corrosion or broken wire excessive consumption, which will reduce the lifeboat davit wire load, so that the lifeboat may fall.

The failure of the hook may be caused by severe corrosion of the release hook or poor closure of the lifeboat. In serious cases, the lifeboat will fall and serious casualties will be caused. If the components and handrails inside the lifeboat are corroded or fail, it is also easy to cause the components and handrails to be damaged or broken when being used in the lifeboat, thus causing casualties.

It is important to remember that the ship should not swerve or advance while the release hook is still in place to prevent injury from the line or from getting sucked into the propellers with the lifeboat.

Surround the lifeboat with tools or debris that will hinder the operation of the lifeboat. If the bottom of the lifeboat is not properly plugged when the lifeboat is released, it may cause the lifeboat to sink after falling into the water.

In the process of operating the release hook to release, attention should also be paid to the proper control, speed too fast, may lead to the lifeboat fall and serious casualties. Moreover, if the lifeboat falls too fast, it may cause the lifeboat to turn over. If people are with the lifeboat, it will lead to casualties. If the lifeboat is too high in the air, it may fall down and cause casualties.
www.lifeboatdavits.com